DB Research L.L.P., takes pride in protecting our customers. Our products are sold online by DB Drive’s Website only. We do not authorize the sale of our products through third-party sales, such as eBay, social media, marketplace, forums, or other online groups. Purchases made through an unauthorized source will limit product support and void our manufacturers warranty. Buy Authorized.

OSW10D4

OSW10D4

$349.95

10″ 4Ω DVC Subwoofer

 

Download Manual

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Category:
000

10″ 4Ω DVC Subwoofer

 

Download Manual

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The double stitched foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

  • Non-Pressed Paper cone
  • Double-stitched foam surround
  • Dual poly-cotton dampeners
  • Die-cast aluminum vented basket
  • Rubber gasket trim ring
  • Large Gauge compression terminals
  • Protective magnet cover

Physical Structure

Outside Diameter (A) 10.86″ (276mm)
Cutout Diameter (B) 9.15″ (232.41mm)
Mounting Depth (C) 6.15″ (156.21mm)
General Specifications
Structure 10″ (25.4cm) Woofer
Dynamic Power Handling 2500 Watts
Nominal Power Handling 600 Watts
Impedance Dual 4Ω Voice Coil
Parameters
Resonant Frequency (fs) 41.63 Hz
D.C. Voice Coil Resistance (Re) 3.2Ω x 3.2Ω
Mechanical Quality Factor (Qms) 3.156
Electrical Quality Factor (Qes) 0.582
Total Quality Factor (Qts) 0.492
Equivalent Air Volume to Cms (Vas) 9.79 L
Mass of Diaphragm/Coil (Mms) 289.93 g
Force Factor (Bl) 14.437
Sound Pressure Level (SPL) 82.7 dB

Recommended Enclosures

Woofer Cut-out 9.15″ (232.41 mm)
Mounting Depth 6.15″ (156.21mm)
Sealed Box 1 ft3 (28.32L)
Vented Box 1.2 ft3 (33.98L)
• Vent Area 7.7 in2 (45.6 cm2)
• Vent Length 11″ (27.94cm)
• Tuning 36Hz
Dynamic Power 2500 Watts
Nominal Power 600 Watts

Wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).

4 Ohm DVC Configuration

Related products